Filter
Top Products
Security Pro 1000 11
If you are interactive with your panel and the panel hangs up on you, the system is
calling in a report to the central monitoring station or a pager, due to an action made by
you or someone at the security system site.
How to Use
Your
Touchpads
Touchpads are used to control the security system from any location within or near
your home.
Remote Handheld Touchpad
Interfacing with the system using a Remote Handheld Touchpad is similar to using the
panel.
System Status
Press System Status once to hear information about your system from the panel. See
“Status Beeps”.
ARM Doors & Windows
Press Arm Doors & Windows button once to turn the security system protection on
for all protected doors and windows.
Press twice to eliminate the pre-programmed entry delay.
ARM Motion Sensors
Note
Depending upon how your
dealer programmed your
panel, you may be required
to enter your access code to
arm the system.
Press Arm Motion Sensors button once to turn protection on for all Motion Sensors.
Use when no one is home. This is usually used in combination with ARM Doors &
Windows. Press twice to activate the Latchkey feature.
Disarm
Press Disarm button once and enter your access code using the NUMERIC buttons to
turn security protection off. To subdisarm the system, enter the master access code.
Subdisarm
Enter your master access code using the NUMERIC buttons while the system is dis-
armed. Panel will announce, system disarmed. The Disarm button on the panel will
begin to blink.
ARM Doors/Windows with No Entry Delay
and Motions with Latchkey
‚ + CODE + 2 + 2 + 3 + 3
Lights On/Off ‚ + CODE + 0
System Status ‚ + CODE + # + 1
AVM ‚ + CODE + 5 + X (X = a command
from the Audio Verification Set,
1=Talk, 2=VOX, 3=Listen)
Hang Up ‚ + CODE + 9
Phone Commands
Panel Function Phone Command
7
4
1
89
5
2
6
3
Off
sP
EMERGENCY
On
d&sres Hol hBtoeKy
DISARM
SYSTEM
STATUS
Doors &
Windows
ARM
ARM
Sensors
Motio
n
-