Filter
Top Products
Concord 4 Series Security Systems 7
Level 2—STAY
Use this level to arm perimeter doors and windows only. Interior devices such as motion sensors
remain off so you can stay inside the premises without setting off an alarm. If you wish, you can
exit through a designated delay door after arming to Level 2—STAY.
To arm to Level 2—STAY using a touchpad:
1. Close all protected perimeter doors and windows.
2. Press
2 at any touchpad. Touchpads display, “ENTER CODE.”
Note
If Quick Arm feature is on,
an access code is not
required to arm the system
to Level 2— STAY.
3. Enter your Access Code. Touchpads display, “Armed to STAY” and the system sounds two
short beeps.
4. If leaving the premises, exit through a designated delay door immediately.
To arm to Level 2—STAY using a keychain touchpad:
Press the Lock button once to go from Level 1 to Level 2.
Level 3—AWAY
Use this level to arm perimeter door/window sensors and interior motion sensors for maximum
protection.
To arm to Level 3—AWAY using a touchpad:
1. Close all perimeter doors and windows.
2. Press
3 at any touchpad. Touchpads display, “ENTER CODE.”
Note
If Quick Arm feature is on,
an access code is not
required to arm the system
to Level 3— AWAY.
3. Enter your Access Code. Touchpads display, “ARMED TO AWAY” and the system sounds
three short beeps.
4. Exit through a designated delay door immediately.
To arm to Level 3—AWAY using a keychain touchpad:
• Press the Lock button twice to go from Level 1 to Level 3, or once to go from Level 2 to
Level 3.
Quick Arm
Note
Contact your installer if you
want to use this feature.
This feature lets you arm your system without using an access code. Disarming the system still
requires entering an access code.
Quick Arm to Level 2:
From Level 1--Press 2.
Quick Arm to Level 3:
From Level 1 or 2--Press 3.
Quick Exit
Your system may be set up to let you exit and re-enter the premises within two minutes, without
disarming and rearming the system. This is useful when you want to quickly step outside to pick
up the newspaper without disarming your system.
To use Quick Exit:
Important !
If you step outside and are
planning to come back in, do
not close the door behind
you!
1. When the system is armed to 2—STAY, Press D at any touchpad (opening the door without
pressing
D will cause an alarm).
2. Open a designated delay door and go outside. Leave the door open if you are planning to
come back in!
3. Return within two minutes and close the door. The system will rearm to 2—STAY.