Filter
Top Products
INSTALL THE INDOOR UNIT
• Route the tubes and wiring from the right side of
the indoor unit. Cut off the tailings from the
chassis as necessary.
1. Cut off tailings 1 when routing the wiring only.
2. Cut off tailings 1 and 2 (or tailings 1, 2 and 3)
when routing both the wiring and tubing. 1 and
2 below are the recommended tubing.
Installation Instructions
13
INSTALLATION (cont.)
2
7
INSTALL THE INDOOR UNIT (cont.)
• Wrap the tubes and wiring and pull them through
the cut-off-tailings hole.
• Hang the mounting slots of the indoor unit on
the upper tabs of the mounting plate and make
sure it is firm enough.
• The height of the installed location should be
79″ or more from the floor.
7
2 Right rear tube
Tailings 2
1 Right
tube
Tailings 1
Tailings 3
Control cord (for
cooling/heating
type only)
Wrapping tape
Connection tubes
Power
connection cord
Drainage hose