Stovax Open Log Burning Convector Fireboxes Indoor Fireplace User Manual


 
PR8074
Poker
7.3 Remove components carefully. Heat can remain long after
use, See Diagram 16
PR8076PR8075
Multi-fuel Kit Cast Basket
Ashpan
Ashpan
Grate
Damper/
Multi-fuel
tool
Where a steel frame is fitted on the multi-fuel kit version:
•Removethelogbarandbottomframeplatebefore
removing the grates (Using the tool supplied) and Multi-fuel
box ashpan, see Installation Section 2 & 3
Once the bottom frame plate is removed access can be
gained to ash build up on the base plate with a vacuum
cleaner
7.4 Use gloves, or place the ash into a Stovax Ash Caddy
(Stovax Part No. 4227)
7.5 Do not place hot ash in a bin made from plastic or any
other combustible material.
8. EXTENDED BURNING
8.1 It is possible to lengthen the re-fuelling period.
In order to do this:
•De-ashpriortorefuelling
•SetAirDampercontrol(Primaryifmulti-fuelkitfitted)to
low combustion setting
•Usesmokelessfuelorsmall,thicklogsdependingonfuel
desired
9. OVER-FIRING
9.1 Do not over-fill with fuel or use at maximum output for
long periods or over-firing can occur. If the flue pipe, flue
collar or top plate glow red the appliance is over-firing:
•Close the Air Damper (Primary if multi-fuel kit fitted)
control to reduce the output
9.2 Over-firing can cause permanent damage to the appliance.
10. CHIMNEY FIRE
10.1 If a chimney fire occurs:
•Shut all Air Damper and Multi-fuel controls immediately
•Evacuate the building
•Call the fire brigade
•Do not re-enter the building until it is confirmed safe
10.2 Do not use the appliance after a chimney fire until:
a) It has been inspected by a registered installer,
confirming the appliance is safe to use*
b) The chimney system inspected and swept by a chimney
sweep, confirming the system is structurally sound and free
from obstruction before re-use.**
c) It is repaired as required before re-use. Use only
genuine Stovax replacement parts to keep your appliance in
safe and efficient working order.
11. GENERAL CLEANING
11.1 Allow appliance to cool thoroughly to avoid risk of burns:
•Cleanregularly,accordingtothelevelofuse
•Giveattentiontothedampersystem,fluewaysand
removing ash
Regular cleaning and maintenance will help give many years
of safe use.
•CleanmattblackappliancesusingStovaxCollodialblack
or Stovax Grate Polish
To refresh painted finishes use Stovax Thermolac paint.
•Cleanfinishesusingwarmsoapywaterandasoftclean
cloth
•Donotuseaerosolspraysnearanoperatingappliance
Wipe dry with a soft clean cloth
before re-lighting. Do not
leave unit without drying, as this may cause rust.
Do not use abrasive cleaner or cleaning pads.
9
USER INSTRUCTIONS
In the U.K:
* registered with HETAS (GB only)/INFO (Republic of
Ireland only)
** This should be done by a NACS registered (UK only)/
INFO registered (Eire only) chimney sweep, who will issue
you with a certificate.
† Note: It is recommended to use a lint free cloth when cleaning
this appliance