6
USER INSTRUCTIONS
AR0900
6
6.4 • Placethreecoalsequallyspacedontherearofthefuel
bed so they touch the rear panel, Diagram 7
AR0901
7
6.5 • Placefivecoalsonthefrontofthefuelbedsotheyrest
on the front coal effect and lean against the vertical fingers,
Diagram 8
AR0902
8
AR0900
6
6.4 • Placethreecoalsequallyspacedontherearofthefuel
bed so they touch the rear panel, Diagram 7
AR0901
7
6.5 • Placefivecoalsonthefrontofthefuelbedsotheyrest
on the front coal effect and lean against the vertical fingers,
Diagram 8
AR0902
8
6.6 • Placetheremainingfourcoalsbetweenthetworowsof
coals
• Rotatethecoalstoensuretheyaresecureonthefuel
bed, Diagram 9
AR0903
9
6.7 • Closethedoorandtightentheboltanddomednut
NOTE: ENSURE THAT THE COALS ARE POSITIONED, AS
DETAILED ABOVE. ONLY USE THE CORRECT AMOUNT
OF COALS, AS SPECIFIED IN THE DIAGRAMS
7. GAZCO FLUE SURE SYSTEM
7.1 The stove is fitted with the Gazco Flue Sure System, which
will act to cut off the gas supply to the burners in the event
of incorrect operation of the flue. If the system acts to cut
off the gas supply, this indicates that there is insufficient flue
pull. If this occurs a minimum of 10 minutes should be
allowed before trying to relight. Continued operation of this
safety device means there may be a serious problem with
the flue system. A qualified gas engineer should inspect this.
Do not use the stove until an engineer says it is safe to
do so.
8. THE FLAME FAILURE DEVICE
8.1 This is a safety feature incorporated in all GAZCO fires,
which automatically switches off the gas supply if the pilot
light goes out and fails to heat the thermocouple.