Filter
Top Products
190-01007-A1 System Maintenance Manual GTN 6XX/7XX Part 23 AML STC
Rev. 7 Page 3-13
3.4.4.2 ChartView™ Enablement (GTN 7XX Only)
The GTN 7XX can display Jeppesen charts using the optional
ChartView feature, which must be activated. To configure
which Charts to display, touch either None, FliteCharts, or
ChartView. If ChartView is selected, it must be enabled as
described below.
NOTE
For first time Chartview enablement, refer to the GTN
6XX/7XX AML STC IM, P/N 190-01007-A3, for
additional requirements and checkout procedures. This
manual only describes the necessary steps to re-enable
the feature for existing installations.
1. Turn the GTN off by pulling the NAV/GPS circuit
breaker.
2. Remove the database SD card from the data card slot
and insert the ChartView Enablement Card,
P/N 010-00878-04, which was used at the initial installation.
3. Enter configuration mode on the GTN by applying power to the GTN (closing the circuit breaker)
while holding the HOME key.
4. Go to the Charts page from the GTN Options page. Touch the ChartView key.
5. When the ChartView feature is activated, the ChartView key will be lit green, as shown in
Figure 3-14.
NOTE
The feature enablement card should be provided to the customer after service has been
completed.
Figure 3-14. Chart Configuration
Page