Furuno 1932 MARK-2 Indoor Furnishings User Manual


 
1-2
1.3 Fastening the Radiator to
the Radiator Bracket
For your reference, scanner installation ma-
terials list appears in the packing lists at the
back of this manual.
1. Remove the radiator cap from the radia-
tor bracket.
2. Coat contacting surface between scan-
ner radiator and radiator bracket with an-
ticorrosive sealant as shown in Figure 1-2
(scanner unit XN10A) or Figure 1-3 (scan-
ner unit XN12A).
Coat hatched area with
anticorrosive sealant.
Groove
Radiator
Figure 1-2 Coating the bottom of
scanner radiator for XN10A with
anticorrosive sealant
RADIATOR BRACKET
(top view)
Coat hatched area with
anticorrosive sealant.
10mm
Figure 1-3 Coating scanner bracket
for XN12A with anticorrosive sealant
3. Coat threaded holes on the scanner ra-
diator with anticorrosive sealant.
4. Grease the O-ring and set it to the radia-
tor bracket.
5. Lay the scanner radiator on the radiator
bracket.
6. Coat the radiator fixing bolts (4 pcs.) with
anticorrosive sealant. Fasten the scanner
radiator to the radiator bracket with the
radiator fixing bolts, flat washers and
spring washers.
Flat washer
Spring washer
Hex head bolt
(M8 x 30)
Radiator bracket
Coat bolts with
anticorrosive
sealant.
Scanner
radiator
O-ring
Coat threaded
holes with anti-
corrosive
sealant.
Figure 1-4 Fastening the radiator bracket to
the scanner unit chassis (shown: XN12A)
1.4 Mounting the Scanner Unit
The scanner unit can be mounted using the
fixing holes on the outside (240 x 240 nm) or
inside (140 x 150 nm) the scanner unit.
Outside fixing holes
Use the hex head bolt ( supplied ) to mount
the scanner unit as below.
1 . Lay the corrosion-proof rubber mat ( sup-
plied) on the mounting platform.
Ground
terminal
Rubber
mat
Bow mark
Figure 1-5 Location of rubber mat