Filter
Top Products
6-6
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
Heating mode light
is ON with power
switch in OFF
position. After
initial startup, fryer
continues to heat
until trouble light
comes on. Frypot
temperature is
above 410F (210°C).
Failed controller.
If available, substitute a controller
known to be working for the
suspect controller. If the fryer
functions correctly, order
replacement from FASC.
6.4 Troubleshooting the Built-in Filtration System
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
A. Thermal overload switch has
tripped on an overheated motor.
Test: If the pump stopped
suddenly during the filtering
process, especially if after several
filtering cycles, the pump motor
has probably overheated. Place
the filter handle in the OFF
position, allow the pump to cool
for at least 45 minutes, and then
press the reset button on the pump
motor. Attempt to activate the
pump.
A. If the pump runs normally after
resetting the thermal overload
switch, the pump was overheated.
Always filter with the cooking oil
at or near frying temperature.
Allow the pump motor to cool off
for about ten minutes after
filtering two full frypots one after
the other.
Check the filter paper between
filterings. Replace the paper if
there is a large accumulation of
sediment.
Pump won’t start.
OR
Pump stops during
filtering.
B. Failed filter handle microswitch.
Test: If this is a multi-pot fryer,
attempt to operate the pump using
a different handle. If the pump
starts, the handle microswitch is
either out of alignment or has
failed.
When the handle is placed in the
ON position, the lever on the
microswitch should be firmly
pressed against the switch. If so,
the switch has failed. If not, the
switch is loose and/or misaligned.
B. If the switch is loose, tighten the
nuts and bolts holding it in place,
ensuring that when the handle is
placed in the ON position, the
lever on the microswitch is
pressed firmly against the switch.
If the switch has failed, call
FASC.