Filter
Top Products
6-3
PROBLEM PROBABLE CAUSES CORRECTIVE ACTION
A. Failed computer/controller.
A. If available, substitute a
computer/controller known to be
working for the suspect
computer/controller. If the fryer
functions correctly, order
replacement from FASC.
Display shows
,
heating indicator
cycles on and off
normally, but
burners will not
light and blower is
not running.
B. Damaged computer/controller
wiring harness.
B. If available, substitute a harness
known to be good for the suspect
harness. If the fryer functions
correctly, order replacement
harness from FASC.
Fryer is slow coming
out of melt cycle.
Display shows
a short time
after coming out of
melt cycle.
Dirty or obstructed combustion air
blower.
Clean and adjust per instructions
in Chapter 5 of this manual.
Fryer is operating
normally, but
recovery is slow
when cooking.
Dirty or obstructed combustion air
blower.
Clean and adjust per instructions
in Chapter 5 of this manual.
A. Dirty or obstructed combustion air
blower.
A. Clean and adjust per instructions
in Chapter 5 of this manual.
B. Dirty or obstructed gas valve vent
tube (non-CE fryers only).
B. Clean per instructions in Chapter
5 of this manual.
Fryer is operating
normally, but
produces a popping
sound when burners
ignite.
C. Malfunctioning combustion air
blower.
C. If blower is slow to come up to
speed, contact FASC for service.
Display shows
and alarm
sounds, but fryer
operates normally
(false alarm).
Failed computer/controller.
If available, substitute a
computer/controller known to be
working for the suspect
computer/controller. If the fryer
functions correctly, order
replacement from FASC.
Computer will not
go into program
mode or some
buttons do not
actuate.
Failed computer/controller.
If available, substitute a
computer/controller known to be
working for the suspect
computer/controller. If the fryer
functions correctly, order
replacement from FASC.
Heat indicator is on
and blower is
running, but burner
will not ignite.
Blown fuse on interface board or
ignition module.
Replace fuse.