Filter
Top Products
12
920-087-04
Plastic handles
Plastic
grommets
1. Remove the center support and weatherboard if still in stalled
in the sleeve.
2. Insert six plastic grommets into the grille openings from the
outside of the grille as shown in Figure 9.
3. Insert two #8 x 3/8" sheet metal screws (provided) in the top
two outside edge plastic grommets, and tighten them half way
into the grommets.
4. CAUTION: Bodily injury can be caused by grilles falling from
a building during installation. It is rec om mend ed that a safety
line be attached to the grille and an anchor point inside the
building during installation.
Installation Instructions Model PXGA Standard Grille
5. Grasp the grille by the attached plastic handles. Po si tion
it with the con den sate drain knock outs facing down. From
in side the build ing, ma neu ver the grille through the wall
sleeve and pull to ward you until the screw heads are
inserted into the key hole slots at the top of the wall sleeve.
Tight en the two screws com plete ly.
6. Insert the remaining screws into the remaining holes and
tighten securely.
Wall sleeve
Weatherboard
Center support
Description
Stamped Aluminum Grille
Plastic Grommets
#8 x
3
/
8
" Sheet Metal Screws
Quantity
1
6
6
PXGA Standard Grille
Standard Grille
Figure 9