FMI CGMFP Indoor Fireplace User Manual


 
www.fmiproducts.com
119315-01D 5
PRODUCT
IDENTIFICATION
Piezo
Ignitor
Screen
Access
Door
Log
Control
Knob
Figure 1 - Vent-Free Mini Compact
Fireplace
PRODUCT FEATURES

This replace has a pilot with an Oxygen
Depletion Sensing (ODS) safety shutoff
system. The ODS/pilot is a required feature
for vent-free room replaces. The ODS/pilot
shuts off the replace if there is not enough
fresh air.
ELECTRONIC IGNITOR

This heater has an electronic ignitor to light
heater fuel supply.
OPTIONAL REMOTE
CONTROL ACCESSORIES

There are four optional remote controls that
can be purchased separately for Remote-
Ready Models only:
wall switch
hand-held ON/OFF remote
wall thermostat
hand-held thermostat remote
See Accessories, page 34.
ASSEMBLY
WARNING: Always have

-
 

-
    

    
   



Tools Required:
Phillips screwdriver
5/16" hex wrench
slotted screwdriver
scissors
1. Remove two screws that hold replace
screen in place for shipping. These
screws are located near top of screen.
Discard screws. Lift replace screen up
and pull out to remove (see Figure 2, page
6). Set screen aside until installation has
been completed.
2. Remove all packaging from inside of unit.
3. Remove bubble wrap from logs and
discard.
Brick
Liners
Electronic
Ignitor
Screen
Access Door
Log
Control
Knob
Brick
Liners
Remote
Control