Filter
Top Products
– 7 –
System Overview (cont’d)
Using Schedules
Your system may have been programmed with schedules for
automatically arming, disarming and activating various devices
and/or performing other system functions at predetermined times.
Users can modify some of these schedules by manually delaying a
closing time, using temporary schedules, or by programming special
user schedules. Refer to the USING SCHEDULES section at the end
of this manual for scheduling related procedures.
Device Timers
The system provides up to 20 "timers" which can be used to control
various devices, such as lights or appliances. These timers are similar
in concept to the individual appliance timers that might be purchased
at a department store. The devices that can be controlled are
programmed into the system by the installer. Up to 32 of these
devices can be programmed. Refer to the PROGRAMMING DEVICE
TIMERS section for procedures.
To Access Another Partition (GOTO Command)
Each keypad is assigned a default partition for display purposes, and
will show only that partition's information. But, if the user is
authorized, a keypad in one partition can be used to perform system
functions in another partition by using the GOTO command. Note
that only those partitions authorized and programmed by the installer
can be accessed in this manner.
To GOTO another partition, enter your security code, then press ✴
followed by the desired partition number (1-8).
The keypad will remain in the new partition until directed to go to
another partition, or until 120 seconds has elapsed with no keypad
activity. Entering partition number 0 will return the keypad to its
original partition.