Filter
Top Products
– 17 –
Security Codes & Authority Levels (cont’d)
Level 7 Limited Use: Can arm and disarm the system for a
predetermined number of times. Use #84
mode to set number of times.
To view your authority level and system capabilities:
1. Enter your code + ✴
+ ✴ .
2. The keypad will display the partition(s) that you are authorized to
operate, and your user number and authority level in each
partition.
General Rules on Authority Levels and Changes
• A user may not delete or change the user code of the SAME or
HIGHER authority than which he is assigned.
• A user may only ADD users to a LOWER authority level.
• A user may assign access codes only to those partitions to which the
user adding the code has access. (ex. a user with access to only
partition 1 cannot assign codes in partition 2.)
• The only way to assign a user's authority level is by using the "Add
A User" procedure. To change a user's authority level, that user
must first be deleted, then added again.
• A user can only be DELETED or CHANGED from within the
partition he is assigned.
• User numbers must be entered as 3-digit entries. Single digit user
numbers must be preceded by a "00" (example, 003, 004, etc.).
Security codes are entered as 4-digit numbers.
• Before assigning a security code, be sure it does not conflict with
any DURESS code.
Note: When adding, changing or deleting users, all other alpha
keypads in that partition will display "User Edit Mode – Please Stand
By", and key depressions (except Panic) at those keypads will be
ignored. Panic key depressions will cause an alarm and terminate
user entry.