Filter
Top Products
9
4. Place the Post Support (7) on top of the 3 assembled Support Legs
and align the holes in the Post Support with the holes in the Support Legs.
Insert 2 - M6x30mm Bolts (B) through the two holes in Support Post and through
M6 Washer (I) then through hole in Support Leg and affix a 6mm Nut (J) to the
bolt. Repeat with 5 remainingM6x30mm Bolts, 6M Washers and 6mm Nuts. Hand
tighten initially then tighten with a wrench when all bolts have been inserted.
5. Attach the lower piece of the Post Assembly (4) to the Support Post using
4 - M6x10mm Bolts (F).
6. Then screw the upper piece of the Post Assembly onto the
lower piece of the Post Assembly by turning clockwise.
5. Place Tank Housing (6) onto Base (9). Slide Tank Housing over
the assembled Upper/Lower Post and down over the Post Supports.
Rest Tank Housing on Base.
ASSEMBLY