Filter
Top Products
13
3. If leak is detected at regulator/cylinder valve connection, disconnect, reconnect, and perform another leak
check. If you continue to see bubbles after several attempts, cylinder valve is defective. Call our customer
service hotline at 1-866-985-7877, 9 a.m. – 6 p.m., EST, Monday – Friday
IF NO BUBBLES APPEAR AT ANY CONNECTION, THE CONNECTIONS ARE SECURE.
Note: Whenever gas connections are loosened or removed, you must perform a complete leak test.
Caution: Do not attempt to operate this appliance until you have read and understand all Safety Information in
this manual and all assembly is complete and leak checks have been performed.
Before Turning Gas Supply ON:
1. Your heater was designed and approved for OUTDOOR use only. Do NOT use it inside a building, garage, or
any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and other flammable vapors or
liquids.
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections are tight and there are no
leaks.
4. Be sure the cylinder cover is clear of debris. Be sure any component removed during assembly or servicing is
replaced and fastened prior to starting.
Before Lighting:
1. Heater should be thoroughly inspected before each use, and by a qualified service person at least annually. If
re-lighting a hot heater, always wait at least 5 minutes.
2. Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak
tested. If the hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly
specified by the manufacturer.
Lighting:
NOTE: For initial start or after any cylinder change, hold the Control Knob in for 2 minutes to purge air from all
gas lines before proceeding. When lighting the pilot flame make sure that the Control Knob is held in while
pressing the igniter button. The Control Knob can be released after the pilot flame has been lit for 20-30 seconds.
1. Turn the Control Knob to the “OFF” position.
2. Fully open the LP cylinder valve.
3. Press and turn the Control Knob to "HI" position (counterclockwise 90˚).
Press down the control know and hold 3-5 seconds.
4. While holding down the Control Knob, push the RED igniter button
several times until the pilot flame ignites. Keep the Control Knob fully
pushed in for an additional 30 seconds after the burner ignites, then
release the Control Knob.
Note: If the pilot flame does not light or if it goes out, repeat Step 3-4 above.
5. To increase the flame, turn the Control Knob towards "HI" and to decrease
the flame, turn the Control Knob towards "LO."
6. To turn the appliance OFF, push down the Control Knob and turn
clockwise to the "OFF" position.
7. Turn the gas cylinder valve to OFF or closed.
8. Wait at least 5 minutes before attempting to re-light the heater
If you experience any ignition problems, please consult “Troubleshooting” on page 16.
Caution: Avoid inhaling fumes emitted from the heater’s first use. Smoke and odor from the burning of oils used in the manufacturing will
appear. Both smoke and odor will dissipate after approximately 30 minutes. The heater should NOT produce thick black smoke.
OPERATING INSTRUCTIONS