Filter
Top Products
11
8. While supporting heater, tilt the Head Assembly and slide 1 pcs - M8 Washer (H)
over each of the 3 Barrel Bolts, then slide the assembled Reflector over the 3 Barrel
Bolts that extend from the Head Assembly. Use the 3 pcs - Wing Nuts (G) and
3 pcs - M8 Washers (H) to secure the assembled Reflector to the Head Assembly of
the heater. Once you have tightened the Wing Nuts, return the heater to an upright
position.
9. Connect the hose and regulator to the LP cylinder. The LP cylinder is sold separately. Use a standard 20 lb.
propane cylinder only. Lift the Tank Housing up and rest it on the top of the assembled Post Supports.
Screw Regulator (G) onto Gas Hose (E). Do not cross thread. Hand tighten securely. Attach Regulator (G) to
valve on LP cylinder and hand tighten securely. Place LP tank onto base of heater and secure LP Tank
on base by tightening M8x25 Bolts (E) in the LPG Cylinder Holders. Lower the Tank Housing.
NOTE: Use this heater only with a propane vapor withdrawal supply system. See
chapter 5 of the standard for storage and handling of liquefied petroleum gas,
ANSI/NFPA 58. Your local library or fire department should have this book.
ASSEMBLY