Filter
Top Products
8
2. Attach one Anchoring Arm (11) to Base (9) with 2 - M6x12 Bolts (D), M6 Washers (I) and M6 Nuts (J) as shown
below (repeat with the other 2 anchoring arms so all 3 are attached to Base). NOTE: Only 2 Anchoring Arms
can be used in conjunction with the Wheel Assembly.
Once heater is completely assembled, if you wish to anchor heater to ground, insert Anchoring Pins through
Anchoring Arms and directly into ground as shown.
*Optional waterbox: For models that come with a waterbox, the
waterbox will be pre-assembled to the base. To fill the waterbox,
you must remove the 4 bolts/nuts that secure the base to the
waterbox. Then twist off the plastic cap on the side of the waterbox
and fill the waterbox with water or sand. Replace plastic cap. Slide
base back over the waterbox and insert bolts through holes in base
and waterbox and secure by tightening washers on ends of bolts.
You may find it easier to fill the waterbox prior to attaching wheels.
3. Attach the LPG Cylinder Holders (10) to the Base (9) using
6 - M6x12 Bolts (D), 6 - M6 Washers (I) and M6 Nuts (J). Then align
the Support Legs (8) with the holes in the Base and insert 1 - M8x16 Bolt (C)
through the hole in Support Leg and into Base and hand tighten to secure
Support Leg to Base. Repeat until all 3 Support Legs are attached to
the Base. Once all 3 are assembled, tighten the bolts with a wrench.
Adjust the M8x25 Bolt (E) that comes pre-assembled in the LPG Cylinder
Holders to secure the LPG Cylinder (see Step 9.)
ASSEMBLY