Filter
Top Products
9
Set
Temperature/
Timer Display
Temperature/
Timer Hour
Controls
Timer
Control
Fan Speed
Control
Mode
Control
Power
Control
Power Control
The Power Control turns the unit on and off.
Set Temperature/Timer Display
The Set Temperature/Timer Display shows the set temperature when the unit
is in operation and hours when the timer is being set.
THE TEMPERATURE DISPLAY ONLY SHOWS THE SET TEMPERATURE, NOT THE
ACTUAL ROOM TEMPERATURE.
Temperature/Timer Hour Controls
These buttons are used to raise or lower the set temperature. By depressing
both buttons at once, the display will toggle between Celsius and Fahrenheit.
When the timer is being set, these buttons are used to change the hour
setting.
Mode Control Fan, Cool, Heat (Heat models only), and Energy Save.
A green light will indicate which mode is currently being utilized.
Cool Mode – The unit will circulate and cool the air.
Fan Mode – The unit will only circulate the air.
Heat Mode (Heat models only)- The unit will circulate and heat the air.
Heater Safety Feature- When heater is powered off, low fan will
automatically stay on and run for 60 seconds to ensure the removal of
residual heat, meanwhile, the Low Fan LED blinks until the low fan
stops.
Energy Save Mode – The fan will switch from the set fan speed to Low
whenever the compressor turns off in response to the thermostat. When
the compressor cycles back on, the unit will return to the original fan
setting.
Fan Speed Control
High, Medium*, Low and Auto
The settings are adjusted with the Fan Speed Control, each time the button
is depressed it changes the setting. A green light will indicate which setting
is currently being used.
When the AUTO feature is selected while the air conditioner is in the COOL
or HEAT mode, the fan speeds will change automatically as the temperature
in the room changes.
COOL Mode
•7°or more above the set temperature will use HI fan.
• 4° or less above the set temperature will use LO fan.
HEAT Mode
• 9° or more below the set temperature will use HI fan.
• 4° or less below the set temperature will use LO fan.
*MEDIUM FAN NOT available on HEAT models.
Timer Control
The timer can be set to either turn the unit on or off.
To turn the unit on using the Timer:
Depress the timer key when the power is off, the display will read 00. Adjust
to the desired number of hours before TURN ON using the up/down arrows.
•The display will show the time by hours left until TURN ON.
•To Turn the timer off, depress the timer key.
•A green light next to the Timer Control indicates that the timer is set.
To turn the unit OFF using the Timer:
Depress the timer key when the power is on, the display will read 00. Adjust
to the desired number of hours before TURN OFF using the up/down arrows.
The display will automatically go back to the set temperature after 10
seconds.
•To display the amount of time left until TURN OFF, depress the timer button
once.
•To turn the TIMER OFF, depress the timer button twice.
•A green light next to the Timer Control indicates that the timer is set.
Built-in three minute timing delay.
If the electronic controls do not respond to
touch pad or remote control commands, you
must unplug the unit from the electrical outlet
for five seconds and then plug the unit back in.
Auto restart feature:
In the event of a power failure, this feature allows
the unit to resume operation once power has been
restored, retaining the most recent settings. Upon
restoration of power, the timer mode may need to
be reset if being utilized.
ELECTRONIC CONTROLS
OPERATION
CAUTION
Heat/Cool models or units with electric heat
are designed to be used only as a
supplemental heat source.They should be
used in addition to regular heating systems
and never as the primary source of heat.