Filter
Top Products
Excalibur
®
P95-3 Zero Clearance Direct Vent Gas Fireplace
24
INSTALLATION
CONVERSION KIT# 773-969 FROM NG TO LP
FOR P95-3 USING SIT 820 NOVA GAS VALVE
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER
IF IN DOUBT DO NOT DO THIS CONVERSION !!
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part # Description
1 904-431 Burner Orifi ce #49
1 918-590 Label "Converted to
LPG"
1 908-528 Red "LPG" label
1 908-529 5/32" Allen Key
1 910-037 LP Injector (Pilot Orifi ce)
1 918-486 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part # Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
1 904-438 Plug Nylon 0.750 Hole,
Black
1 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator Battery
Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
7) Pull off the pilot cap to expose the pilot
orifi ce.
8) Unscrew the pilot orifi ce with the allen key
and replace with the LP pilot orifi ce in the
kit and replace pilot cap.
6) Remove the 2 screws, one on each side
of the burner. Slide the burner to the left
and then lift out.
Remove screw
Slide the burner to
the left and lift out.
Remove
screw
Burner
Orifi ce
1) Turn the gas off.
2) Turn control knob to the “OFF” position.
3) Remove the glass frame.
4) Remove the logs, embers, and brick panels
(if used).
5) Remove the burner/grate assembly, fi rst
by removing the two screws, one on each
side of the grate, then pull out the grate.
Installation of LPG
Conversion Kit:
Allen Key
9) Remove burner orifi ce with a 1/2" wrench
and discard. Use another wrench to hold
on to the elbow behind the orifi ce.
10) Reinstall new burner orifi ce LP stamped
#49 and tighten.
11) Remove the black protection cap by
hand from the high-low knob (Fig.1).
Fig.1