Filter
Top Products
14
How to Remove and Check Clear Tube
Low suction or poor pickup may be due to a blockage in the vacuum cleaner.
To Check Attachment Hose
1. Remove hose and check suction at end of hose - if little or no suction, check
dust cup and filters. Empty dust cup and clean or replace filters, if needed . If no
improvement proceed to step 2.
NOTE: Turn off the switch and unplug the electrical cord before checking tubes.
To Check Large base hose coming from hood, go directly to step 2.
2. To release base hose, rotate twist lock clockwise to release from hose adapter.
3. Clear base hose of any blockages.
4. Reconnect base hose to hose adapter. Place base hose in hose adapter and
rotate twistlock counter clockwise to secure.
5. At clear tube/cleaner connection, use a coin to turn quarterturn lock downward
to release tube.
6. Remove large clear tube by swinging out, up and away from cleaner.
7. Check for blockages in cleaner opening.
8. At clear tube/hose connection, rotate twistlock clockwise to release clear tube
from hose.
9. Check for blockages in clear tube and hose opening,
NOTE: Clean tube with mild detergent. Do not put in a dishwasher. Make sure
all parts are completely dry prior to reassembling.
1
2
5
6
8
3
4
7
9