Filter
Top Products
5. Insert right end into base. Make sure it is fully into
position. Ensure belt is centered on brush roll pulley.
NOTE: The new belt will appear to be too large. This
is normal.
How To Replace Brush Roll Belt (continued)
5
6. Replace base plate by first inserting all 4 front tabs
into slots on base. Rotate down on cleaner and replace
3 screws.
Slots
6
How to Remove the Cyclonic Dust Cup
11
NOTE: Turn off the switch and unplug the electrical
cord before emptying dust cup. Never operate
the vacuum cleaner without the dust cup or
filters properly installed.
1. With handle in upright position, locate dust cup lever
on the front of the cleaner. When facing the cleaner,
slide the lever to the left to the release position. The
dust cup platform will drop down.
2. Slide dust cup out of the dust cup compartment.
Dust Cup
Lever
How to Replace the Cyclonic Dust Cup
1. See the above illustration. When replacing dust cup
tilt handle back slightly for easier installation. Locate
the notch on the dust cup and the tab on the inside of
the dust cup compartment. Line them up and slide
the dust cup into place on the dust cup platform.
2. Check to be sure the filter tube and dust cup are
properly lined up with the seals at the top of the
dust cup compartment.
3. Slide the dust cup lever to the right to the engage
position to secure the filter tube and dust cup.
Notch
Tab
Dust Cup
Platform
HOW TO MAINTAIN (continued)
The instructions in this booklet serve as a guide to routine maintenance. To avoid unnecessary service calls, check the dust
cup, filters, belt and brush roll often.
Brush
Roll
Pulley