Filter
Top Products
21
Secondary Installation
BRICK PANEL INSTALLATION:
Caution: Use only the type of ember material supplied with this replace. Due to the irregular
size of the ember material, there may be more than required. Use of other foreign materials
on the burners may create dangerous conditions.
If over time, through cleaning and servicing, these embers require replacement , contact your nearest
Enviro dealer.
Remove the glass door and the log set. Remove
the burner tray by undoing the hold-down screws
located in the center of the pan burner and sliding
the assembly to the left, then up.
Gently pull right brick side panel inward from the
bottom back. Pull towards the back then out,
freeing it from the front retainer.
Caution: The pilot may damage panel. Remove
left side panel in the same fashion.
To install, insert front edge of brick panel into the
retainer and very gently move panel forward and
out until ush against rebox side.
Figure 31: Focus Log Placement Complete.
Figure 32: Focus Log Set Burning.
Figure 33: Brick Panel Installation.
IMPORTANT: Upon the rst light
up after installing logs and embers,
watch for ignition to ALL burner
ports. If a long delay is noted wait
for the appliance to cool down:
• Open the front door of the
appliance
• Carefully reposition the embers,
making sure that the burner ports
are not plugged or blocked.