Filter
Top Products
KNOB “A”: Fan Controller. By adjusting the knob you will vary the rate of airflow into the room by varying
the speed of the convection blower. When you first start the stove, it should be placed in the “OFF”
position in order to heat the unit as quickly as possible. Once the room has come up to temperature, the
control may be set to a comfortable level. *Note: The convection blower may cycle to high automatically
depending on the setting of knobs “A” and “B”. This is a normal safety feature of the unit.
KNOB “B”: Dial a Fire Heat Output Knob. This knob controls the amount of heat output. The dial
has a scale with the blue zone representing the coolest setting of the stove, and the red zone
representing the hottest setting. Note: The scale on the Dial A Fire knob represents a range, not
exact times. Wood pellets of differing quality may affect the performance of the stove. If the stove has
trouble operating at the ends of its’ range, turn the heat output knob back slightly.
TURNING YOUR PELLET STOVE OFF:
To turn your stove off, simply turn the HEAT OUTPUT knob (“Knob B”) counter-clockwise until the knob
clicks to the “OFF” position. This will stop the feed of pellets. The blowers will continue to run and cool
the stove. When cool enough, the stove will shut down.
DO NOT unplug unit while combustion fan is operating. This may lead to smoke
escaping from the stove.
Operating Instructions
OPERATING YOUR PELLET STOVE:
Convection
blower speed
control;Knob A
Auger light
Start-up
switch
Dial-A-Fire
heat output;
Knob B
Figure 2: Dial-A-Fire control panel.
1. Check and fill hopper with pellets.
2. Make sure unit is plugged into a working outlet.
3. Switch the power “ON” by pushing the start-up switch once
only.
4. Turn knob “B” to the 12 o’clock position. (Lower grade
pellets may need a higher setting on the feed rate).
NOTES: It will take longer to light if the hopper has been
completely emptied or is the first fire up. The flashing
green light corresponds to the auger feed rate.
5. Wait until the fire is established, then turn knob “B” to the
desired heat output. The stove may not be able to burn in
the BLUE ZONE if poor quality wood pellets are being used.
Adjust the slider-damper to the appropriate setting (see
“SLIDER/DAMPER SETTING” section).
6. If the stove should shut off after fifteen (15) minutes and
there is still a fire in the firebox – press the start up switch
once more. If the fire went out, return to Step 2 and re-
light the stove.
7