Filter
Top Products
24
Installation
ASSEMBLING THE INSERT SURROUND PANELS:
1. To assemble the surround panels, lay the panels face down on a soft flat surface and align the outer
edges of the sides with the top panel. Bolt the sides to the top using two (2) ” nuts and bolts on
each side (refer to Figure 30).
2. Assemble the trim using the corner hardware and screws supplied in the faceplate packaging. Install
corner hardware into the side trim, then push into the top frame (refer to Figure 31).
3. Place the brass trim over the panel assembly.
4. Place the assembled surround panel around the stove; align the slots with the screw heads. Push back
and then down to engage the surround slots on the mounting screws. Make sure the top surround
panel sits flat on the stove.
Magnetic Strips
Two (2) pieces make
up one (1) corner bracket
Corner Brackets
Figure 30: Assembling the
Surround Panel, back view.
Figure 31: Assembling Trim for Surround Panel.
INSTALLATION AND REMOVAL OF INSERT SURROUND PANELS:
Plug the wiring harness into the control panel (see Figure 28). Place
the assembled surround panel around the stove; align the slots
with the screw heads. Push surround in then down to engage the
surround slots on the mounting screws (see Figure 32). Make sure
the top surround panel sits flat behind the stove top.
REMOVAL:
When maintenance is required on the unit the surround must be
removed. Pull the surround straight up till it stops then pull it out
about 4” (10 cm) and rest the surround on top of the unit while the
control panel is removed or disconnected.
If electrical connection is required for maintenance, remove the
control board control panel from the surround.
If electrical connection is not required for maintenance, remove the
wiring harness from the bottom of the control board control.
Figure 32: Panel placed on unit.