Filter
Top Products
Installation
INSTALLATION OF DOOR A:
REMOVE PAINTED DOOR A:
Remove the door assembly by opening the door, use the Allen
key with the wood handle that was provided with the stove (see
Figure 33). Lift the door up over the hinge pins and out. Lay the
door down on a soft surface.
Remove the two end covers using a T-20 screwdriver, each side
has two screws (see Figure 34). Place end covers and screws
to the side.
There are four screws, one in each corner, that hold the painted
door in place (see Figure 35), remove the screws with a T-
20 screwdriver and place the screws to the side. Discard the
painted door A.
INSTALL PLATED DOOR A:
Place the plated door (gold or nickel) in position and fasten with
the four T-20 screws that were used on the painted door. Ensure
WARNING: DO NOT install the EF4 plated door A when unit is hot or is in operation.
the screws are tight.
Reinstall the two end covers with their two screws each. Tighten the screws.
Close the door assembly using the Allen key with the wood handle.
CLEANING THE PLATED DOOR A:
It is important to note that fingerprints and other marks can leave a permanent stain on plated finishes.
To avoid this, give the face a quick wipe with denatured alcohol on a soft cloth BEFORE lighting the
fireplace. Never clean the face when it is hot, let the stove completely cool off. Do not use other
cleaners as they may leave a residue, which can become permanently etched into the surface.
Figure 33: EF4 complete door.
Figure 34: EF4 end screws. Figure 35: EF4 front screws.
25