Filter
Top Products
ASH PAN (2-3 days)
Monitor the ash level every week. Remember that different pellet fuels will have different ash contents.
Ash content is a good indication of fuel efficiency and quality. Dump the ashes into a metal container
stored away from combustibles. Refer to “Warnings and Recommendations” for disposal of ashes. DO
NOT PLACE UNBURNED OR RAW PELLET FUEL IN ASH PAN.
Vacuum the ash pan and inside the pedestal. CAUTION: BECAUSE THE FLY ASH IS VERY FINE, THE USE
OF A FINE FILTER VACUUM BAG WILL BE REQUIRED TO PREVENT ASH FROM BEING BLOWN BACK
INTO THE ROOM. Please pay special attention that there are no hot ashes in the firebox or there could
be a possibility of a fire hazard inside the vacuum cleaner. Place all hot ashes into a non-combustible
container.
FREESTANDING ASH PAN:
The EF2 pellet stove freestanding’s ash pan is located under the burner, in the pedestal, and has
a latching mechanism to secure it. To remove the ash pan, unlock the latch on the ash pan and
then pull the pan out.
FIREPLACE INSERT AND BUILT-IN HEATER ASH PAN:
The EF2 pellet stove insert’s ash pan is located behind the lower grill.
HEAT EXCHANGER TUBES (2-3 days)
The handle for the heat exchanger cleaning rod is pointed out in
Figure 4. This handle is to be pulled back and forth a few times
(ONLY WHEN THE UNIT IS COLD) in order to clean away any
fly ash that may have collected on the heat exchanger tubes. As
different types of pellets produce different amounts of ash, cleaning
of the tubes should be done on a regular basis to enable the unit to
run efficiently.
FRESH AIR INTAKE (season)
Inspect periodically to be sure that it is not clogged with any foreign
materials.
EXHAUST PASSAGES (season)
For bi-weekly clean out, ash may be removed from behind the steel plates by rotating the circular covers
located behind the right and left side panels. Loosen the screw on the disks and open, this will allow
vacuuming behind the firebox liner’s plates.
Removal of the firebox backing for bi-annual cleaning:
• Remove the top baffle.
• Lubricate and then remove the seven (7) screws that hold the brick liner in place. Tilt the top of the
brick panel towards the firebox opening and remove from the firebox
• Remove the top rod by first removing the screw that holds it in place, then slide the rod sideways
• Pull the side panels into the center of the firebox, then out
• Pull the center panel out.
• Clean and vacuum all passages thoroughly.
Routine Cleaning and Maintenance
Figure 4: EF2 Heat exchanger rod.
Heat exchange
tube cleaner rod
9