Filter
Top Products
15
Installation
OUTSIDE VERTICAL INSTALLATIONS:
To accomplish a outside vertical pipe installation, follow steps 1 through 5 in the “INSIDE VERTICAL INSTALLATIONS
- FREESTANDING” section and then finish it by performing the following (refer to Figure 14).
1. Install a tee with clean out on the outside of the house.
2. Install vent pipe upward from the tee. Make sure that you install support brackets to keep the vent
straight and secure.
3. Install ceiling thimble and secure the flashing as you go through the roof.
4. Ensure that the rain cap is approximately 900 mm (36”) above the roof.
Rain cap
Flashing
900mm
(36")
100mm
(4")
Tee with
cleanout
Fresh air
intake
75mm (3")
Clearance
Support
bracket
Type "L"
vent
Figure 14: Outside Vertical Installation.