Filter
Top Products
Rosemount Tank Radar REX
Chapter 7 Bus Modems
7-12
Installation Manual
308014EN, Edition 4
May 2013
Below follows a short configuration description. Details are described in
the Enraf Emulation Guideline (reference number 308013EN) and in
TankMaster WinSetup Reference Manual (reference number
303027EN).
Step 1 Connect the EBM.
Step 2 Configure the gauge in WinSetup.
Step 3 Install a tank in Winsetup: Required only for Hybrid / LPG systems
for which the analog inputs are used. However it is a good idea to
install a tank and associate a gauge to it, because then it is possi-
ble to benefit from the Open Tank View function.
Step 4 Configure the gauge by using the Hybrid Calculation window
(Hybrid
system) or LPG Setup window (LPG system) in Winsetup.
Step 5 Set holding registers for free water level measurements.
Step 6 Enter information into the Enraf Emulation window in WinSetup.
Set Enraf mode and move EBM switch from Modbus to Normal
(Enraf).
Step 7 Close Enraf Emulation window. The gauge now acts like an Enraf
instrument and the EBM can be disconnected. Connect the field-
bus to the CIU.