Filter
Top Products
11
Setting Operating
Frequency of Wall Control
and Receiver (Figure 20)
Your wall control and receiver have code switches
which must be set in one of 16 possible code combi-
nations. The four levers (numbered 1, 2, 3, and 4) on
the switches are factory-set in the ON (up) position.
Change the switch settings as follows:
1. Slide the four switch levers in the wall control to
your choice of ON (up) or down positions. Use a
ball-point pen or small screwdriver and slide the
levers firmly up or down.
2. In the receiver, slide the four switch levers to the
same positions as set in the wall control. Make
sure the levers on both switches are in the same
positions, otherwise the fan will not operate.
ON
1
234
WALL CONTROL
LEVERS
CODE
SWITCH
SW105
RECEIVER
CODE
SWITCH
SW114 WALL
CONTROL
ON
1
234
RECEIVER SWITCH
LEVERS
HI
HI
MED
MED
LOW
LOW
FA
N
O
F
F
REV
REV
LIG
H
T
Figure 20
The SW114 wall control transmits the command
signals via radio waves to the SW105 receiver
installed in the ceiling fan ceiling cover. The
SW105 receiver is required for the SW114 wall
control to function. Power for the SW114 wall
control comes from the 12V battery, located in the
wall control.
Replacement 12V batteries recommended are
Duracell MN21 and Eveready A23.
1. Install the 12V battery (supplied) into the wall
control (Figure 21).
2. The SW114 wall control is supplied with a white,
ivory or almond color cover. Choose the style that
best suits your needs and snap the cover onto the
wall control (Figure 21).
12V BATTERY
WALL
CONTROL
COVER
SW114 WALL
CONTROL
H
I
H
I
M
E
D
M
E
D
L
O
W
L
O
W
FAN OFF
R
E
V
R
E
V
L
IG
H
T
Figure 21
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse or circuit breaker box.
WARNING
Installation
of Wall Control
3. Install the wall control onto the outlet box using the
supplied screws (Figure 22).
4. Install decorator wall plate (not included) using the
two screws provided with wall plate (Figure 22).
SW114 WALL
CONTROL
DECORATIVE WALL
PLATE (Not Included)
OUTLET
BOX
WALL PLATE
SCREW (2)
WALL CONTROL
SCREW (2)
R
E
V
H
I
M
E
D
L
O
W
F
A
N
O
F
F
L
I
G
H
T
Figure 22