Filter
Top Products
17. You have now completed the
initial assembly of your new ceiling
fan. You can now proceed with
hanging and wiring your fan.
16. Reinstall the hanger ball on the
downrod (Figure 16) as follows.
Route the motor leads through the
hanger ball and slide the hanger ball
over the downrod. Install the pin
through the holes at the top of the
downrod and slide the hanger ball up
the downrod, aligning the ball so the
pin is captured in the groove in the top
of the hanger ball. Pull the hanger ball
up tight against the pin and securely
tighten the setscrew in the hanger
ball. A loose setscrew could create
fan wobble.
15. Slide the ceiling cover over the
downrod until it rests on the coupling
cover (Figure 15). Be sure the cover
is oriented correctly, with the large
opening at the top.
DOWNROD
COUPLING
COVER
CEILING
COVER
Figure 15
HANGER BALL
DOWNROD
CEILING
COVER
SETSCREW
PIN
Figure 16
10
It is critical that the clevis pin in the motor
coupling is properly installed and the
setscrew securely tightened. Failure to
verify that the pin and setscrew are
properly installed (as shown in Figure 12)
could result in the fan falling.
!
WARNING
How to Hang
Your Ceiling Fan
The fan must be hung with at least 7' of
clearance from floor to blades (Figure 17).
!
WARNING
The outlet box and joist must be securely
mounted and capable of supporting at
least 50 lbs. Use only a U.L. outlet box
listed as “Acceptable for Fan Support of
50 Lbs. or Less”.
!
WARNING
To reduce the risk of fire, electric shock,
or personal injury, mount fan to outlet box
marked “Acceptable for Fan Support of
50 Lbs. or Less”, and use screws
supplied with outlet box. Most outlet
boxes commonly used for support of light
fixtures are not acceptable for fan
support and may need to be replaced.
Consult a qualified electrician if in doubt.
!
WARNING
CEILING
FLOOR
AT
LEAST
7'
Figure 17
1. Securely attach the hanger bracket to
the outlet box using the two screws
supplied with the outlet box (Figure 18).
BP7335 Palazzo 1/9/07 9:05 AM Page 10