Filter
Top Products
6
INSTINST
INSTINST
INST
ALLAALLA
ALLAALLA
ALLA
TION TION
TION TION
TION
AND CONFIGURAAND CONFIGURA
AND CONFIGURAAND CONFIGURA
AND CONFIGURA
TIONTION
TIONTION
TION
Shut off electricity at main fuse or
circuit breaker box until installation is
complete AND the jumper leads (fig.
10, page 17) on the back of the
thermostat are configured properly.
Remove the front cover of the old
thermostat. With wires still attached,
remove wall plate from the wall.
Identify each wire attached to the
thermostat using one of the labels
enclosed with the new thermostat.
Disconnect the wires from the old
thermostat one at a time. DO NOT let
the wires fall back into the wall.
Install the new thermostat using the
following procedures.
REMOVE OLD THERMOSTATREMOVE OLD THERMOSTAT
REMOVE OLD THERMOSTATREMOVE OLD THERMOSTAT
REMOVE OLD THERMOSTAT
Remove packing material from the
thermostat. Place fingers of one hand
on the center top and bottom portion
of the thermostat. Grasp the base in the
other hand on top and bottom center
and gently pull straight out. Forcing or
prying on the thermostat will cause
damage to the unit.
Place the base over the hole in the wall
where the wires come out and mark
mounting hole locations base as a
template. Drill
3
/16” pilot holes, and
install screw anchors in the wall.
Run wires through hole in base and
attach base to wall (see fig. 2, page 7).
Insert the wires into the terminals on
the base using the appropriate wiring
diagram and tighten the terminal
screws.
ATTACH BASE TO WALLATTACH BASE TO WALL
ATTACH BASE TO WALLATTACH BASE TO WALL
ATTACH BASE TO WALL
This product does not contain mercury.
However, this product may replace a
unit which contains mercury.
Do not open mercury cells. If a cell
becomes damaged, do not touch any
spilled mercury. Wearing non-
absorbent gloves, take up the spilled
mercury with sand or other absorbent
material and place into a container
which can be sealed. If a cell becomes
damaged, the unit should be discarded.
Mercury must not be discarded in
household trash. When the unit this
product is replacing is to be discarded,
place in a suitable container and return
to White-Rodgers at 2895 Harrison
Street, Batesville, AR 72501 for proper
disposal.
ATTENTION!ATTENTION!
ATTENTION!ATTENTION!
ATTENTION!