Filter
Top Products
6. This will bring up a Connect to dialog box. From the pull
down next to “Connect using:”, select the Com port to
which the Protocol Adapter is connected (see
ILLUSTRATION 8). Start with Com port 1 (or the next
lowest available number) if you are unsure which one to
use. Click OK.
7. A COM1 Properties dialog box should appear. Use the
pull-down menus or type in the following for each
selection (see ILLUSTRATION 9):
Bits per second: 9600 (or 19200 if thermostats
are configured for this baud rate)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: none
Click OK.
14
ILLUSTRATION 8 – Select Com Port
ILLUSTRATION 9 – Connection Properties