Filter
Top Products
7
Outputs On Off
User Code Level: 5 and above.
Function: Allows you to turn the system relay outputs on and off.
This function is used to individually turn your system’s relay outputs
on and off. Your system may use these outputs to control such
devices as smoke detectors, heat detectors, and other notification
appliances.
Turning the Outputs On and Off
1. Access the User Menu.
2. Press COMMAND until OUTPUTS ON/OFF? displays.
3. Press any SELECT key to display OUTPUT: - ON OFF.
4. Enter the output number you want to turn on or off. The output
number will appear in the display.
5. With the output number displayed, press the SELECT key under
ON or OFF. The output is then turned on or off, depending on
your selection, and remains in that state until you change it.
Under certain conditions, some outputs cannot be turned on. If you
select a restricted output, the display shows CANNOT TURN ON.
6. The system automatically removes the output number and a new
output number can be entered. Refer back to step 4.
Press the ARROW key to exit the User Menu.
User Menu
Zone Status
User Code Level: All users.
Function: Displays a list of bypassed or alarmed zones. Also allows
you to check the status of individual zones.
Zone Status can be used to give you a list of zones by category or
display the current status of an individual zone number. The three
categories that apply to the XR2400F are Alarmed, Bypassed, and
Number.
Checking the Zone Status
1. Access the User Menu.
2. Press COMMAND until ZONE STATUS? is displayed.
3. Press any SELECT key to display ARM BYPS ALR NBR.
4. Select BYPS for a list of zones that are currently bypassed.
4. Select ALR for a list of zones that have gone into alarm during
the current or previous armed period.
5. Press NBR and ZONE NO: - will be displayed.
6. At the ZONE NO: - prompt, enter the zone number you want to
check and press COMMAND. The zone number and name is
displayed followed by its status. For example, a zone status for
zone one (1) might be OFFICE SMOKE - OKAY. The displays
are
-OKAY = the zone is in a normal condition
-BYPAS = the zone is bypassed
-BAD = the zone is in a bad condition
7. After displaying the zone status, ZONE: - returns for you to enter
another zone number.