Filter
Top Products
14
shock or damage to persons.
Remove the rebox from the mantel.1.
Lay unit on its back.2.
Remove the 12 Philips screws that fasten the bottom 3.
cover to the rest of the rebox. There are: two (2)
screws on each side; two (2) screws on the back panel
(you may have to tip the bottom of the replace up
if it is laying on its back), four (4) screws in the front
directly under the control panel; and two (2) screws
on the bottom of the replace (Figure 8). The bottom
panel is now free to be removed.
Locate the Remote Control Receiver (Figure 20) 4.
mounted underneath the log set support panel and
disconnect the six (6) wiring clips noting their original
locations.
Disconnect the three (3) wire leads from the 3-Position 5.
Switch. (The wires are hard-wired to the Remote
Control Receiver) (Figure 20)
!
NOTE: A at head screwdriver can be used to gently
pry between the end of the connectors and the switch to
release the wires.
Pull the Antenna wire through the bottom of the 6.
chassis.
Locate the three (3) LED indicator lights from inside the 7.
bottom assembly of the rebox. (Figure 18)
!
NOTE: Using a athead screwdriver, gently push on the
rear edge of the plastic bushing surrounding each LED and
push each LED out from the front of the control panel.
Clear any silicon that may be present and rmly grasp 8.
the sheathed ends of the wires leading to each LED
and remove the plastic bushing from each LED. Each
LED and paired wires can be fed back through the front
control panel and into the bottom assembly area.
The Remote Control Receiver is fastened to the 9.
underside of the ember bed support by four (4)
mounting studs, one in each corner (Figure 20). Either
squeeze each mounting stud’s clasp, using needle
nose pliers, to release, or use side cutters to cut and
remove each of the four corner mounting studs on the
board.
!
NOTE: If mounting studs are cut, replacement
mounting studs will need to be inserted from underneath
ember bed. Follow steps 1 - 5 of Partially Reective
Glass Replacement procedure on Page 9 to do this. It
is recommended to attempt to release the control board
without cutting mounting studs, although new mounting
studs are provided.
Properly orient the replacement Remote Control 10.
receiver and adhere to the control panel with the
supplied/existing mounting studs.
Once the remote control receiver is mounted, 11.
reconnect and reassemble the replace in reverse
order as described above.
Figure 20
3-Position SwitchLEDs (3)
All Hard-
wired Ends
3-Position
Switch
Wires (3)
Antenna
Wire
Remote
Control
Receiver
Mounting
Studs (4)