Filter
Top Products
www.desatech.com
111826-02J 5
PRODUCT
IDENTIFICATION
Figure 1 - Product Identication
Hand-Held
Remote Control
Chassis
Assembly
Control
Knob
Log Set Assembly
UNPACKING
CAUTION: Do not remove the
-
1. Remove log set assembly from carton.
Note: Do not pick up assembly by logs. This
could damage heater. Always handle assembly
by grate.
2. Remove control cover oor media components.
3. Remove all protective packaging applied to
log set for shipment.
3. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought heater.
PRODUCT FEATURES
This unitized gas log set is tested and approved to
ANSI Z21.60a and CSA 2.26a-2000 as a vented
decorative appliance.
SAFETY DEVICE
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot shuts off the heater if there is not
enough fresh air.
ELECTRONIC IGNITION SYSTEM
This system has an electronic ignitor. This system
requires no matches or other sources to light heater.
Receiver requires 4 AA batteries (included), hand-
held remote control requires a 12-volt battery and
a 3-volt button cell battery for the LCD display
(both included).
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are two optional remote accessories available
for the PDG log set models that come standard with
the BTB log set models:
• wall switch
• hand-held ON/OFF remote
See Accessories, page 19.
Chassis
Assembly
Log Set
Assembly
Selector
Switch
Flame
Adjustment
Knob
Control
Knob
Selector
Switch
Flame
Adjustment
Knob
BTB Models
Remote
Receiver
Electronic
Ignitor
Electronic
Ignitor