Filter
Top Products
www.desatech.com
119162-01C 21
10. Wait one minute and put switch in ON posi-
tion to light burners. Note: AUTO is only
functional when using GWMT1 or GWMS2
optional accessories. If hand-held remote
control is installed but not being used, slide
remote selector switch to ON (It must be in
this position for burners to light. Switch will
be in REMOTE position if using hand-held
remote).
11. Set ame adjustment knob to any level be-
tween HI and LO.
CAUTION: Do not try to ad-
WARNING: Make sure the
remote selector switch is in the
-
matically with selector switch in
OPERATING HEATER
Continued
Figure 30 - Pilot (Propane/LP)
Ignitor
Electrode
Pilot
Burner
Figure 31 - Pilot (Natural)
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS
TO AppLIANCE
1. Turn control knob clockwise to the
OFF position.
2a. Set switch in the OFF position.
2b. Set
selector switch in the OFF position to prevent
draining battery.
You may shut off the burners and keep the pilot lit
by doing one of the following:
1. Turn control knob clockwise to the
PILOT position.
2. Use remote control manual OFF button.
3. Set switch in the OFF position.
MANUAL LIGHTING
pROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 20.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 9 through 11,
Lighting Instructions, page 20.
OpTIONAL HAND-HELD
REMOTE OpERATION
Note: All remote control accessories must be
purchased separately (see Accessories, page 33).
Follow instructions included with the remote
control.
-
Lighting
Instructions
After lighting, let pilot ame burn for about one
minute. Turn control knob to ON position. Adjust
ame adjustment knob anywhere between HI and
LO. Slide the selector switch to the REMOTE posi-
tion (see Figure 32, page 22). Note: The burner
may light if hand-held remote was on when selec-
tor switch was last turned off. You can now turn
the burner on and off with the hand-held remote
control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot is
not lit. This will drain the battery.