Filter
Top Products
www.desatech.com
116412-01B 5
PRODUCT
IDENTIFICATION
Figure 1 - Product Identication
Log Set
Chassis Assembly
LOCAL CODES
Install and use the heater with care. Follow all
local codes. In the absence of local codes, use the
latest edition of the National Fuel Gas Code ANSI
Z223.1/NFPA 54*
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Battery march park
Quincy, MA 02269
Note: Where listed vented decorative logs are
required, thermostat operations is not permitted.
The installation of appliances designed for manu-
factured home (U.S. only) or mobile home instal-
lation must conform with the Standard CAN/CSA
Z240 MH, Standard, Title 24 CFR, Part 3280, in
the United States or when such a Standard is not
applicable, ANSI/NCSBCS A225.1/NFPA 501A
Manufactured Home Installations Standard.
UNPACkING
-
1.
Remove log set assembly from carton.
Note: Do not pick up assembly by logs.
This could damage the unit. Always handle
assembly by grate.
2. Remove all protective packaging applied to
log set for shipment.
3. Check all items for any shipping damage. If
damaged, promptly inform dealer where you
bought appliance.
OPTIONAL REMOTE
CONTROL ACCESSORIES
There are four optional remote controls that can
be purchased separately:
Wall switch Hand-held ON/OFF remote
Wall thermostat Hand-held thermostat remote
See Accessories, page 26.
The wall thermostat or hand-held thermostat may not
be used where vented decorative listings is required.
PRODUCT FEATURES
OPERATION
This heater is clean burning. It requires no outside
venting. There is no heat loss out a vent or up a
chimney. Heat is generated by both realistic ames
and glowing coals. This heater is designed for
vent-free operation with ue damper closed. It
has been tested and approved to ANSI Z21.11.2
standard for unvented heaters. State and local
codes in some areas prohibit the use of vent-free
heaters. This heater may also be operated as a
vented decorative (ANSI Z21.60) product by
opening the ue damper.
This heater has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shut off system. The
ODS/pilot is a required feature for vent-free room
heaters. The ODS/pilot shuts off the heater if there
is not enough fresh air.
PIEZO IGNITION SYSTEM
This heater has a piezo ignitor. This system re-
quires no matches, batteries or other sources to
light heater.
State of Massachusetts: The installation
must be made by a licensed plumber or
gas tter in the Commonwealth of Mas-
sachusetts.
Sellers of unvented propane or natural
gas-red supplemental room heaters shall
provide to each purchaser a copy of 527
CMR 30 upon sale of the unit.
Vent-free gas products are prohibited for
bedroom and bathroom installation in the
Commonwealth of Massachusetts.