Filter
Top Products
20
103280
INSTALLING
Continued
WARNING
Failure to position the parts in accordance with these diagrams or failure
to use only parts specifically approved with this heater may result in
property damage or personal injury.
INSTALLING LOGS (Split Oak Design Models)
Bottom Middle Log (#2)
Metal Post
Metal Post
Peg
Groove
Groove
Grate
Each log is marked with a number. These numbers will help you identify the log when
installing. It is very important to install these logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place front logs (#1L and #1R) on top of the grate. Make sure the notches in the bottom
of the logs fit over the grate prongs (see Figure 22). Push back of logs flush with metal
grate bar.
Note:
18" model has only one front log.
2. Rest bottom middle log (#2) behind metal posts on front burner. Make sure the grooves in
the bottom of the log fit over the grate. Bring the log forward next to the metal posts. The
pegs on the log must be on top (see Figure 23).
3. Slide the grooves in the back of the rear log (#3) against the rear grate prongs. Make
sure the peg on the log is on top (see Figure 24).
4. Place the top middle log (#4) on the bottom middle log (#2). Make sure the pegs of the
bottom middle log fit securely in the holes of the top middle log (see Figure 25).
Figure 22 - Installing Front Logs
(#1L and #1R)
Grate
Prongs
Metal Grate Bar
Front Log (#1L)
Notch
Front Log (#1R)
Figure 23 - Installing Bottom
Middle Log (#2)
Rear Log (#3)
Peg
Grate
Prong
Grate
Prong
Rear
Burner
Groove
in Back
of Log
Groove
in Back
of Log
Figure 24 - Installing Rear Log (#3)
Top Middle Log (#4)
Hole
Hole
Peg
Peg
Bottom
Middle Log
Figure 25 - Installing Top Log (#4)