Filter
Top Products
18
B-VENT FREESTANDING FIREPLACE
106022
SUN VALLEY STOVE COMPANY
TO TURN OFF GAS
TO APPLIANCE
1. Open lo wer louv er panel.
2a. Set selector switch in the “OFF”
position.
2b. If Using Optional Hand-Held Re-
mote: Set selector switch in the OFF
position to pr event dr aining ba ttery.
3. Turn off all electr ical po wer to the
appliance if ser vice is to be perf ormed .
4. Push in g as contr ol knob slightl y and
turn clockwise to “OFF”.
5. Close lo wer panel.
Shutting Off Burners Only (pilot
stays lit)
You may shut off the burners and keep
the pilot lit by doing one of the following:
1. Turn contr ol knob c lockwise
to the PILO T position.
2. Set selector switch in the OFF position.
MANUAL LIGHTING
PROCEDURE
1. Remove glass door (see Removing/
Replacing Glass Door, page 16).
2. Follow steps 1 thr ough 8 under Light-
ing Instructions.
3. Depress contr ol knob and light pilot
with match.
4. Keep contr ol knob pr essed in f or 30
seconds after lighting pilot. After 30
seconds, release contr ol knob . Now
follow steps 10 thr ough 14, column 2.
5. Replace glass door (see Removing/
Replacing Glass Door, page 16).
OPERATING
FIREPLACE
WARNING: If you do not fol-
low these instructions exactly, a
fire or explosion may result caus-
ing property damage, personal
injury or loss of life.
A. This appliance has a pilot which must
be lighted b y hand . When lighting the
pilot, follow these instr uctions e xactly.
B. BEFORE LIGHTING smell all
around the a ppliance ar ea for gas. Be
sure to smell ne xt to the floor because
some g as is hea vier than air and will
settle on the f loor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use an y phone in y our b uilding .
• Immedia tely call y our g as supplier
from a neighbor's phone . Follow
the gas supplier's instructions.
C. Use onl y your hand to push in or tur n
the g as contr ol knob . Ne ver use tools.
If the knob will not push in or tur n
by hand , don't tr y to repair it, call a
qualified ser vice tec hnician. F orce or
attempted r epair ma y result in a f ire
or explosion.
D. Do not use this appliance if any part
has been under w ater. Immedia tely
call a qualif ied ser vice tec hnician
to inspect the a ppliance and to r e-
place an y par t of the contr ol sys-
tem and an y gas contr ol which has
been under w ater.
FOR YOUR SAFETY
READ BEFORE
LIGHTING
LIGHTING
INSTRUCTIONS
1. STOP! Read the saf ety information
in column one.
2. Open lo wer panel.
3. Turn ON/OFF s witch to “OFF”.
4. Turn off all electr ic po wer to the
fireplace .
5. Push in g as contr ol knob slightl y and
turn clockwise to “OFF”.
6. Wait five (5) min utes to c lear out an y
gas. Then smell f or gas, inc luding
near the f loor. If you smell g as,
STOP! Follow “B” in the saf ety in-
formation in column one . If y ou don't
smell gas, go to the next step.
7. The pilot is located by the main
burner and should not r equir e ac-
cessing f or lighting .
8. Turn knob on g as contr ol counter -
clockwise to “PILOT”.
9. Push in contr ol knob all the w ay and
hold. Immediately light the pilot by
repeatedly depressing the piez o
spark ignitor until a flame appears.
Continue to hold f or about one (1)
minute after the pilot is lit. Release
knob and it will pop back. Pilot
should r emain lit. If it g oes out, re-
peat steps 5 thr ough 8.
•
If knob does not pop up when re-
leased, stop and immediately call your
service technician or gas supplier.
• If the pilot will not sta y lit after se v-
eral tries, turn the g as contr ol knob
to “OFF” and call y our ser vice
technician or g as supplier .
10. Turn gas contr ol counter clockwise
to “ON”.
11. Turn on all electr ic po wer to the
fireplace .
12. Turn the ON/OFF s witch to ON
position.
13. This valve is equipped with a HI/LO
feature. Set f ireplace input as desir ed.
14. Close lo wer panel.
Figure 48 - Control Valve
L
O
H
I
OFF
ON
P
I
L
O
T
Gas Control
Knob
Variable
Control Knob
Piezo Ignitor