Filter
Top Products
www.desatech.com
119505-01E 9
2. Lift and remove firebox bottom (see
Figure 10).
3. If installing GA3750A blower accessory,
see Installing Blower Accessory, page 8.
4. Route exible gas line from equipment
shutoff valve into rebox through side.
is recommended to allow acces-
-
5. Attach gas log heater base to rebox bot-
tom with four screws included with base
(see Installing Heater Base Assembly in
log set owner’s manual).
6. Replace rebox bottom and secure with
screws.
INSTALLATION
Continued
Figure 9 - Routing Blower Accessory
Power Cord for Built-In Installation
Screw
Blower Power Cord
Blower
Support Bracket
Cables From
Electrical Source
Duplex
Outlet
Light your gas appliance with the blower off.
After about 15 minutes, turn the blower on
to deliver heated air at the top louvers. The
blower features a variable control which al-
lows you to select the speed you desire.
Note: Periodically check the louvers of the
rebox and remove any dust, dirt or other
obstructions.
INSTALLING LOG HEATER IN
CAUTION: Do not remove the
1. Remove 4 screws holding rebox bottom
in place.
Figure 10 - Removing Firebox Bottom
5. Connect wires from the electrical box to
duplex outlet. Match wire colors to those
indicated on duplex outlet. Be sure to
connect ground wire.
6. Replace duplex outlet with screw.
7. Plug blower power cord into duplex outlet.
8. Replace bottom of rebox.
INSTALLING FIREPLACE HOOD
-
1. Attach three zinc-colored shoulder screws
to back of hood.
2. Insert hood into hood-mounting slots on
rebox.
3. Hold hood in place. Insert two black Phil-
lips screws through bottom of hood and
tighten. See Figure 11, page 10.