www.desatech.com
119505-01E10
INSTALLATION
Continued
Ring
Figure 12 - Installing Fireplace Screen
Rod
Front and
Rear Hole
Screen
Screw
INSTALLING FIREPLACE SCREEN
1. Insert each rod through nine rings located
at top of screen (see Figure 12).
2. Insert rst rod into rear hole in left side
of rebox. Fasten rod to rear hole near
center of rebox using black shoulder
screw.
3. Insert other rod into front hole on right
side of rebox and fasten using remaining
shoulder screw.
Figure 13 - Rough Opening for Installing
in Wall
Figure 14 - Rough Opening for Installing
in Corner
34
3
/4"
17
3
/4"
33"
Built-in installation of this rebox involves
installing rebox into a framed-in enclosure.
This makes the front of rebox ush with wall.
Optional perimeter trim is available (see Ac-
cessories, page 13) This perimeter trim will
extend past sides of rebox approximately
1/2". This will cover rough edges of the wall
opening. If installing a mantel above the re-
box, you must follow the clearances shown in
Figure 7, page 8. Follow the instructions below
to install the rebox in this manner.
1. Frame in rough opening. Use dimensions
shown in Figure 13 for the rough opening.
If installing in a corner, use dimensions
shown in Figure 14 for the rough opening.
The height is 33", which is the same as
the wall opening in Figure 13.
2. Install gas piping to rebox location. This
installation includes an approved exible
gas line (if allowed by local codes) after
the equipment shutoff valve. The exible
gas line must be the last item installed on
the gas piping. See Connecting to Gas
Supply in log set owner’s manual.
3. Carefully set rebox in front of rough open-
ing with back of rebox inside wall opening.
IMPORTANT: If installing perimeter trim,
see instructions included with perimeter
trim accessory. You must install shoulder
screws now.
OPTIONAL ACCESSORY MANTELS
This rebox may be installed using the corner
or cabinet mantel with hearth base against
a wall in your home. A perimeter trim kit is
included with the mantel accessories (see
Accessories, page 13).
39
3
/8"
27
7
/8"
55
5
/8"
34
3
/4"
Figure 11 - Installing Fireplace Hood
Hood
Hood
Mounting
Slot
Screw
Shoulder
Screw