Desa LGCFTN Indoor Fireplace User Manual


 
www.desatech.com
119508-01A 5
PRODUCT FEATURES

This replace has a pilot with an Oxygen Deple-
tion Sensing (ODS) safety shutoff system. The
ODS/pilot is a required feature for vent-free room
replaces. The ODS/pilot shuts off the replace if
there is not enough fresh air.

This replace has a piezo ignitor. This system
requires no matches, batteries or other sources to
light replace.
THERMOSTATIC HEAT CONTROL
This replace has a thermostat sensing bulb and a
control valve. The thermostat will automatically
modulate the heat output to maintain a consistent
room temperature. This results in greater replace
comfort. This can also result in lower gas bills.
UNPACKING
1. Remove replace from carton.
2. Remove all protective packaging applied to
replace for shipment.
3. Make sure your replace includes one hard-
ware packet.
4. Check replace for any shipping damage. If
replace is damaged, promptly inform dealer
where you bought replace.
ASSEMBLY
WARNING: Always have
    

-



     

-


Tools Required:
Phillips screwdriver slotted screwdriver
5/16" hex wrench scissors

1. Lift screen up and pull out to remove.
Figure 2 - Assembling Fireplace
Log
Screen
Burner Support with
Log Locator Tabs
Branch
Support
Shoulder
Screw
2. Cut two plastic straps to remove the log from
the rebox cavity.
3.
An optional blower is available. See Accessories,
page 27. Install optional blower now. Follow
installation instructions provided with blower.
4. Remove log packaging material and discard
packaging. Gently place log set on burner
support (see Figure 2). The log should t at
against top of burner support and log locator
tabs t into the slots under the log. Do not
allow log to contact ame. If ame contacts
log, soot will be created.
5. Reattach screen by placing the notches in the
screen frame over the shoulder screws and
pushing down.
Figure 3 - Assembling Hood
Sheet Metal
Screws
Firebox
Top
Hood

1. Locate four black phillips sheet metal screws
from the hardware packet.
2. Insert hood between rebox top and louvers
(see Figure 3).
3. Align screw holes on hood with screw holes
on rebox top.
4. Insert screws as shown in Figure 3. Tighten
screws rmly.