Desa GA3700T Indoor Fireplace User Manual


 
www.desatech.com
113109-01G 21
OPERATION
Continued
MANUAL LIGHTING
PROCEDURE
1. Follow steps 1 through 6 under Lighting
Instructions, page 19.
2. Press control knob and light pilot with
match.
3. Keep control knob pressed in for 30 sec-
onds after lighting pilot. After 30 seconds,
release control knob. Now follow steps 9
through 11 under Lighting Instructions,
page 20.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 34). Follow instructions included with
the remote control.

    -
Lighting
Instructions
After lighting, let pilot ame burn for about
one minute. Turn control knob to ON position.
Adjust ame adjustment knob anywhere be-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 35).
Note: The burner may light if hand-held re-
mote was on when selector switch was last
turned off. You can now turn the burner on and
off with the hand-held remote control unit.
IMPORTANT: Do not leave the selector switch
in the REMOTE or ON position when the pilot
is not lit. This will drain the battery.
O
F
F
P
I
L
O
T
O
N
L
O
I
H
AUTO
ON
OFF
Figure 35 - Setting the Selector Switch,
Control Knob and Flame Adjustment
Knob for Remote Operation
Selector Switch in Remote
Position (Optional Hand-
Held Remote Control)
Control Knob
in On Position
Flame Adjustment Knob
Figure 36 - On/Off Hand-Held Remote
Control Unit (HRC100)
Control
Button Turns
Burners On
and Off

Hold the control button on the hand-held
remote until burner turns on. Hold the con-
trol button again until burner turns off (see
Figure 36).
TO LOCK press both buttons on hand-held
remote control until light stops ashing. Hand-
held remote control is now locked. If the re
is on it will be turned off automatically. In the
locked state, the light will not light up when
any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops ashing. The hand-held remote is now
unlocked.


The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure 37,
page 22). To select Fahrenheit/Centigrade
mode display, carefully press the ˚C/˚F mode
button with the end of a paper clip or similar
blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
replace.
3. Press the POWER and LOCK buttons
together to turn off the replace.