Desa GA3700T Indoor Fireplace User Manual


 
www.desatech.com
113109-01G 17
INSTALLATION
Continued
5. Correct all leaks at once.
6. Light replace (see Operation, page 19.
Check all other internal joints for leaks.
7. Turn off replace (see To Turn Off Gas to
Appliance, page 20).
INSTALLING LOGS
CAUTION: Do not remove the




-
    
   
    

    

WARNING: After installa-

  





-

It is very important to install the logs exactly
as instructed. Do not modify logs. Only use
logs supplied with replace.
1. Place back log #1 on grate to t as il-
lustrated in Figure 24. Make sure middle
section at bottom of log set is seated into
“U”-shaped cutout in center of chassis
(see Figure 24). IMPORTANT: Make sure
log does not cover any burner ports (see
Figure 25).
2. Place front log #2 against front grate
prongs as shown in Figure 24.
3. Place crossover log #3 on top of front and
back logs as shown in Figure 24.
Figure 24 - Installing Log Set
Chassis
Crossover
Log #3
Burner
Front
Log #2
Back
Log #1
Grate
Prongs
Figure 25 - Installing Log Set, Top View
Log Set
Burner Ports
4. Install replace screen by slipping notches
of replace screen over screws on front
of replace (see Figure 26, page 18).


-

