111739-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
6
STOVE AND BURNER
SYSTEM ASSEMBLY
Continued
STOVE AND BURNER SYSTEM ASSEMBLY
Removing/Replacing Glass Door
Installing Optional Blower Accessory
REMOVING/REPLACING DOORS AND GLASS
You must remove doors and glass panel to install logs, lava rock, and
ember material. To remove glass panel, you must first remove the
door assembly on stove body.
CAUTION: Do not operate this burner system with
a broken glass panel or without the door assembly
securely in place. For replacement part information
see
Replacement Parts
, page 33.
Figure 8 - Removing Glass Panel from Burner System
Figure 7 - Removing Door Assembly from Stove
1. Lift middle grate and set aside (see Figure 7).
2. Remove two bolts from bottom of stove using an adjustable
wrench or 10 mm socket and one bolt from the top of stove with
an M6 allen wrench to remove door assembly (see Figure 7).
3. Remove the screws from the 2 tabs at the top of the glass panel
while holding door securely keeping it from falling forward.
4. Grasp panel by both sides and ease it upward off of the lower
bracket (see Figure 8)
5. To replace glass panel and door assembly, follow the above
instructions in reverse.
Bolt
Bolt
Door
Assembly
Middle
Grate
NOTICE: If installing blower in an existing stove
burner system with gas connections, shut off gas
supply and disconnect heater from gas supply. Con-
tact a qualified service person to do this.
1. Using an adjustable wrench or 10 mm socket, remove 4 hex
screws securing rear cover to back of stove body (see Figure 9).
2. Separate bottom cover from rear cover by loosening the 8
mounting screws (see Figure 9).
3. Align the holes in the top mounting tabs of blower with the
holes in wall of rear cover. Using the 4 screws provided, mount
blower and tighten screws securely (see Figure 10, page 7).
Figure 9 - Removing Rear Cover and Bottom Cover from Stove
Body
Stove Body
Rear Cover
Bottom Cover
Hex
Screws
Mounting
Screws
Mounting
Screws
Hex Screws
Mounting
Screws
Screw
Glass
Panel
INSTALLING OPTIONAL BLOWER
ACCESSORY