Filter
Top Products
111739-01A
For more information, visit www.desatech.com
For more information, visit www.desatech.com
3
3
SAFETY INFORMATION
Continued
PRODUCT IDENTIFICATION
Figure 1 - Comfort Glow Direct-Vent Burner System Shown
Installed in Approved Comfort Glow Cast Iron Stove Body
(Models CSDBN and CSDPBN)
6. Carefully supervise young children when they are in the room
with stove.
7. Do not modify the burner or stove under any circumstances. Any
parts removed for servicing must be replaced prior to operating
stove or burner system.
8. Turn burner system off and let cool before servicing, install-
ing, or repairing. Only a qualified service person should in-
stall, service, or repair the stove or burner system. Have burner
system inspected annually by a qualified service person.
9. You must keep control compartments, burners, and circulat-
ing air passages clean. More frequent cleaning may be needed
due to excessive lint and dust from carpeting, bedding mate-
rial, pet hair, etc. Turn off the gas valve and pilot light before
cleaning stove or burner system.
10. Have venting system inspected annually by a qualified service
person. If needed, have venting system cleaned or repaired.
See Cleaning and Maintenance, page 29.
11. Keep the area around your stove clear of combustible materi-
als, gasoline, and other flammable vapor and liquids. Do not
run burner system where these are used or stored. Do not place
items such as clothing or decorations on or around stove.
12. Do not use this stove to cook food or burn paper or other objects.
13. Never place anything on top of stove.
14. Do not use any solid fuels (wood, coal, paper, cardboard, etc.)
in this stove. Use only the gas type indicated on burner system
nameplate.
15. This appliance, when installed, must be electrically grounded
in accordance with local codes or, in the absence of local codes,
with the National Electrical Code, ANSI/NFPA 70, or the Ca-
nadian Electrical Code, CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation air in
any way. Provide adequate clearances around air openings into
the combustion chamber along with adequate accessibility
clearance for servicing and proper operation.
17. Do not install stove directly on carpeting, vinyl tile, or any com-
bustible material other than wood. The stove must set on a metal
or wood panel extending the full width and depth of the stove.
18. Do not use stove or burner system if any part has been ex-
posed to or under water. Immediately call a qualified service
person to arrange for replacement of the unit.
19. Do not operate burner system if any log is broken.
20. Do not use a blower insert, heat exchanger insert, or other ac-
cessory not approved for use with this stove.
21. Do not operate burner system with glass door removed, cracked,
or broken.
22. Provide adequate clearances to air openings.
SAFETY INFORMATION
PRODUCT IDENTIFICATION
Blower with
Adjustment
Knob (Optional
Installation)
Lava Rock
Pilot
Assy
Burner
Vent
Opening
Glass
Door Assy
Glowing
Embers
Grate Assembly
Rear
Cover
Cast Iron
Stove Body
ON/OFF
Switch
(Other
Side)
Stove Body
Stove Door (Shown in
the open position)
Piezo
Ignitor
Control
Knob
One Piece Log
Set Inside Stove
Cavity
Screen
Selector
Switch