Filter
Top Products
www.desatech.com
117437-01D22
OPERATING FIREPLACE
Continued
O
F
F
P
I
L
O
T
L
O
I
H
ON
OFF
REMOTE
ON
OFF
O
N
Blower Control Knob
(Optional Accessory)
Variable
Control Knob
Selector Switch in
Remote Position
Gas Control Knob
in ON Position
Figure 36 - Setting the Selector Switch,
Gas Control Knob and Variable Control
Knob for Remote Operation
IMPORTANT: Be sure to press the ON/
OFF buttons on hand-held remote control
unit for up to 3 seconds to assure proper
operation.
2. Press ON/OFF button to turn the burner
on and off.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must
be purchased separately (see Accessories,
page 31). Follow instructions included with
the remote control.
NOTICE: You must light the pilot
before using the hand-held re-
mote control unit. See Lighting
Instructions, page 21.
one minute. Turn control knob to ON position.
-
tween HI and LO. Slide the selector switch to
the REMOTE position (see Figure 36).
Note: Burner may light if hand-held remote
was on when selector switch was last turned
off. You can now turn burner on and off with
hand-held remote control unit.
IMPORTANT: Do not leave selector switch in
the REMOTE or ON position when pilot is not
lit. This will drain battery.
Figure 37 - On/Off Hand-Held Remote
Control Unit HRC100
Control
Button
Indicator
Light
ON/OFF SERIES MODEL HRC100
Hold control button on hand-held remote until
burner turns on. Hold control button again until
burner turns off (see Figure 37).
TO LOCK press both buttons on hand-held
it will be turned off automatically. In locked
is pressed.
press both buttons together
on hand-held remote control until light
stops flashing. Hand-held remote is now
unlocked.
OPTIONAL GWMS2
ON/OFF WALL
MOUNTED SWITCH
WARNING: Do not connect
the appliance gas controls to a
120 VAC power source. Damage
or injury may occur.
Light fireplace as instructed in Lighting
Instructions on page 21 . If using an HRC
-
tor switch to the ON position (see Figure 36).
Wall switch may now be used to turn burner
remote selector switch to the OFF position
and turn gas control knob back to PILOT. Pilot
will remain lit.
IMPORTANT:
knob on heater to the OFF position.