Filter
Top Products
www.desatech.com
117437-01D18
Figure 28 - Removing Louver Panel
Louver
Panel
Spring
Latch
Removing/Replacing Glass Door
WARNING: Handle glass
door panel with care. Do not
strike, slam or otherwise abuse
glass. Do not operate fire-
place with glass door removed,
cracked or broken.
tape remaining fragments onto frame.
into gap between lower glass panel rail
-
sembly until door pins clear locating holes
in bottom face frame (see Figure 29).
2. Swing bottom glass panel assembly out
until door pins on lower rail clear bottom
face frame (see Figure 30).
3. Lower door down until upper door pins are
free of locating holes in spring clips and
place in a safe area.
4. Replace glass panel in reverse order by
lifting up at lower frame rail and locating
bottom pins in holes on lower face frame.
FIREPLACE INSTALLATION
Continued
Figure 30 - Removing/Replacing Glass
Door
Spring Clips
Glass Panel
Frame Rail
1. Lift Up Panel
at Lower Rail
Figure 29 - Removing/Replacing Glass
Door
Locating
Hole
Door Pin
Glass Panel
Frame Rail
2. Swing Out
Panel
3. Lower
Panel Out
Removing Louver Panels
Remove top and bottom louver panels by
simultaneously pulling both top end spring
latches toward center of appliance until they
are disengaged from locating holes (see
Figure 28). Repeat for bottom spring latches
and pull louvers outward. To install or replace
above.