Green and Yellow to
Earth
Blue to
Neutral
13 amp Fuse
Brown to
Live
Cord Clamp
ELECTRICAL REQUIREMENTS
The flexible mains lead is supplied connected to a B.S. 1363 fused plug
having a fuse of 13 amp capacity.Should this plug not fit the socket outlets
in your home, it should be cut off and replaced with a suitable plug, follow-
ing the procedure outlined below.
Note: Such a plug cannot be used for any other appliance and should
therefore be properly disposed of, (having removed the fuse) and not left
where children might find it and plug it into a supply socket - with the
obvious consequent danger.
If the plug is a moulded-on type the fuse cover must be refitted. If the fuse
cover is lost, the plug must not be used until a replacement cover is
obtained. The colour of the correct replacement fuse cover is that of the
coloured insert in the base of the fuse recess or elsewhere on the plug.
Always state this colour when ordering a replacement fuse cover.
N.B. We recommend the use of good quality plugs and wall sockets that
can be switched off when the machine is not in use.
important: the wires in the mains lead fitted to this appliance are coloured
in accordance with the following code:
As the colours of the wires in the mains lead of this appliance may not
correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The wire which is coloured green and yellow must be connected to the
terminal in the plug which is marked with the letter E or by the earth
symbol or coloured green or green and yellow.
The wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black.
The wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
When wiring the plug, ensure that all strands of wire are securely retained
in each terminal. Do not forget to tighten the mains lead clamp on the plug.
If your electricity supply point has only two pin socket outlets, or if you are
in doubt, consult a qualified electrician.
Should the mains lead ever require replacement, it is essential that this
operation be carried out by a qualified electrician and should only be
replaced with a flexible cord of the same size.
Only 13amp replacement fuses which are asta approved to B.S. 1362 should
be fitted. This appliance conforms to the Norms EN 55014 regarding the
suppression of radio interference.
This appliance MUST be Earthed
GREEN AND YELLOW
BLUE
BROWN
EARTH
NEUTRAL
LIVE