Filter
Top Products
INSTALLATION AND OPERATION MANUAL
MF3700, MF3800 Models
Page 5800-345-6007
CumberlandStoveWorks.com
Figure1:OvertempResetButtoninBackPanel
AUTOMATIC SAFETY FEATURES
POWER OUTAGE
During a power outage, the stove will shutdown safely. It
will not automatically restart when the power returns. If the
stove is still at operating termperature when power returns,
the convection fan will circulate the remaining heat in the
stove. See Lighting Instructions.
OVERHEATING
Over Fire Protection:Ifthestoveisbeingoverredor
burning too hot, the high limit switches will automatially shut
down the stove to avoid damage to components. Allow the
stovetocoolatleastonehourbeforerelighting.Theexhaust
overtempislocatedintherearofthestove(gure1),the
augerovertempislocatedontheaugerhousing(gure2).
Both are reset by manually pressing in the button located
between the wire terminals.
CAUTION
Installation and repair of this parlor stove should be
donebyaqualiedserviceperson.Theappliance
should be inspected before use and at least annually
byaqualiedserviceperson.Itisimperativethat
controlcompartments,rebox,andcirculatingair
passageways of the stove be kept clean.
Theoperationofexhaustfanssuchasbathroom
fans, attic fans, etc. might starve the parlor stove
of combustible air creating a negative pressure in
the room. Provide adequate ventilation of the room
accompanying the parlor stove. If not, the pressure
switch may shut off operation of the parlor stove.
The moving parts of this stove are propelled by
high torque electric motors. These parts can cause
severe damage to body parts that get near them.
Keep all body parts away from auger and fans while
the stove is plugged into an electrical outlet. These
moving parts may begin to move at any time the
stove is plugged in.
If the electrical power fails any time when the stove
is hot, keep all stove doors closed.
Vent surfaces can get hot enough to cause burns if
touched. Noncombustible shielding or guards may
be required.
Install vent at clearances specied by the vent
manufacturer.
All venting joints, whether vertical or horizontal,
should be made gas-tight with recommended
sealantsspeciedbyventmanufacturer.
AccordingtoHUD(Housing&UrbanDevelopment)
requirements, when installed in a mobile home, this
stove must be grounded directly to the steel chassis
ofthemobilehomeandboltedtotheoor.Direct
air access must be provided, use a Fresh Air Kit.
For use in the United States. Approved for
installation in mobile homes.
Cumberland Stove Works, manufacturer of this
appliance, reserves the right to alter its products,
specicationsand/orpricewithoutnotice.
WARNING
IF THE ELECTRICAL POWER FAILS ANY TIME WHEN THE
STOVE IS HOT, KEEP ALL STOVE DOORS CLOSED.
THE AUTOMATIC SAFETY FEATURES MUST NOT BE
BYPASSED.
WHEN RESETTING OVERTEMP NEVER USE ANY
CONDUCTORS. COULD CAUSE ELECTRICAL SHOCK
AND/OR DAMAGE TO STOVE.
Figure2:OvertempResetButtononaugerhousing
PUSH TO RESET
PUSH TO RESET